Fujitsu ST4000P manual Modem Connection, PC Card Slot, Removing and Installing Memory Modules

Operation of the Bridge Battery

When installed in the pen tablet PC, the battery provides power to some system components—even when the system is in the Off state. When the battery is removed, power is supplied to these components by a “bridge” battery that is built into the pen tablet PC.

The bridge battery is not designed for long-term opera- tion. To maintain the bridge battery properly, observe the following measures:

P O I N T

•The bridge battery function is disabled if Wake On LAN is enabled in the BIOS.

•The system arrives with the bridge battery in a discharged state. Be sure to charge it sufficiently before relying upon it to support the system in the event of battery removal.

•To prevent draining the bridge battery, always store the system with a charged battery installed.

•If the bridge battery becomes drained, it takes approximately 8 hours for it to be fully recharged.

•The bridge battery charges when the AC Adapter is connected and the system is in On or Off states or Suspend mode. It charges from the battery only when the system is in the On state.

MODEM CONNECTION

P O I N T

The internal 56 Kbps LAN/modem module installed in the Stylistic ST4000P Series pen tablet PC has actual maximum transfer rates of 53 Kbps (receive), 33.6 Kbps (send), and 14.4 Kbps (fax). Download rates are limited to 53 Kbps in the United States due to FCC restrictions.

The Stylistic ST4000P Series pen tablet PC is designed to accept a standard RJ-11 telephone plug. Connect the plug to the modem jack located on the left-hand side of the pen tablet PC (See Figure 1-4 on page 5 for location). The telephone plug can be installed whether or not the pen tablet PC has power applied.

If you need assistance configuring the Stylistic ST4000P Series pen tablet PC modem or LAN, contact your local help desk or your reseller.

U s i n g Y o u r S t y l i s t i c S T 4 0 0 0 P

PC CARD SLOT

The Stylistic ST4000P Series Pen Tablet PC Card slot allows you to install a Type I or Type II PCMCIA Card.

Installing a PC Card

To install a PC card, position the side with the arrow facing up (i.e., when looking at the tablet’s display side, the arrow on the card should be visible.) Slide the card into the PC Card slot, and press it firmly to ensure proper seating. (See Figure 2-3 for location)

If you need assistance installing a PC Card in the Stylistic ST4000P Series pen tablet PC, contact your corporate help desk or your reseller.

Figure 2-3 Installing a PC Card

Removing a PC Card

To remove a PC Card, press the PC Card eject button so that it pops out. Once the button has popped out, press it in firmly to eject the card. (See Figure 2-4 for location)

Figure 2-4 Removing a PC Card

REMOVING AND INSTALLING

MEMORY MODULES

There is one DIMM slot in your pen tablet PC and 256MB on the motherboard. 256MB and 512MB modules are available, so you can install a combination of up to 768MB in the system.

25