11.Fasten cables with the clamps marked with the white arrows in the figure below. Connect the power connector to J1 on the pcb 10P3879 as follows: 1, Brown; 3, Orange; 4, Purple, 6, White.
Location of power switch and pcb 10P3879
12.Fix the rear cover with 14 screws (M4 x 8). (Torque 1.47 ±0.15 Nm; 15 ±1.5 kgm)
13.Temporarily fasten the cover for the power section and connectors with 10 screws (M3 x 8).
14.Fix four spacers for connectors. (Torque: 0.39 ±0.04 Nm; 4 ±0.4 kgm)
15.Temporarily fasten the cover for the power section and connectors with six screws (M3 x 8). (Torque: 0.78 ±0.08 Nm; 8 ±0.8 kgm)
16.Fasten two waterproofing nuts. (Torque: 0.76 ±0.02 Nm; 7.8 ±0.2 kgm)
17.Fasten the cover near the power section and connectors with remaining four screws. (Torque: 0.78 ±0.08 Nm; 8 ±0.8 kgm)
18.Attach the FURUNO logo (supplied) at the cavity in the upper left corner of the display unit.
