Furuno SC-110 Safety Instructions for the Operator, Safety Instructions for the Installer

SAFETY INSTRUCTIONS

The operator and installer must read the applicable safety instructions before attempting to install or operate the equipment.

Indicates a potentially hazardous situation which, if not avoided, WARNING could result in death or serious injury.

CAUTION	can result in minor or moderate injury.
	Indicates a potentially hazardous situation which, if not avoided,
Warning, Caution	Prohibitive Action		Mandatory Action
Safety Instructions for the Operator		Safety Instructions for the Installer

WARNING

ELECTRICAL SHOCK HAZARD

Do not open the equipment.

Only qualified personnel should work inside the equipment.

Do not disassemble or modify the equipment.

Fire, electrical shock or serious injury￿ can result.

Immediately turn off the power at the switchboard if the equipment is￿ emitting smoke or fire.

Continued use can cause fatal damage￿ to the equipment. Contact a FURUNO￿ agent for service.

Do not place liquid-filled containers￿ on the top of the processor unit.

Fire or electrical shock may result if the liquid enters the equipment.

Use the proper fuse.

Use of a wrong fuse can damage the equipment and cause fire.

CAUTION

No one navigation device should ever be solely replied upon for the￿ navigation of a vessel.

Always confirm position against al￿ available aids to navigation (incl. nau-￿ tical charts), for safety of vessel and￿ crew.

WARNING

Turn off the power at the switchboard before beginning the installation.

Fire or electrical shock can result if the power is left on.

Do not install the equipment where it may get wet from rain or water splash.

Water in the equipment can cause fire, electrical shock or damage to the equip-￿ ment.

NOTICE

Observe the following compass safe distances to prevent interference to a magnetic compass:

	Standard	Steering
	Compass	Compass
Display unit	0.4 m	0.3 m
SC-502
Processor unit	0.9 m	0.55 m
SC-1101
Antenna unit	0.3 m	0.3 m
SC-1203F

WARNING LABEL

A warning label is attached to the processor unit. Do not remove the label. If the label is missing or damaged, contact a FURUNO agent or dealer about replacement.

WARNING	WARNING LABEL
	Name:	Warning Label (1)
To avoid electrical shock, do not
remove cover. No user-serviceable	Type:	86-003-1011-1
parts inside.	Code No.: 100-236-231

ii