Furuno SC-110 manual 2-10, 4800BPS, 9600BPS 19200BPS 38400BPS, DATA OUT1 menu, sentences

2.OPERATION

5.Choose SENTENCE and then press the [ENT] key.

DATA OUT1

HDT	VTG	VHW
HDM	GGA	VBW
ROT	GNS	HVE
ATT	GLL	ZDA
VDR	THS	RMC

DATA OUT1 menu, sentences

6.Use the Omnipad to choose a sentence and then press the [ENT] key. HDT: True heading (required for radar, AIS, ECDIS, etc.)

HDM: Magnetic heading (HDM is obtained in this equipment by adding the magnetic variation to HDT.)

THS: True heading and status

ROT: Rate-of-turn data

ATT: True heading, pitching, rolling (FURUNO’s proprietary sentence)

VDR: Set and drift

VTG: Course over ground and ground speed

GGA: Global positioning system (GPS) fix data

GNS: GNSS fix data

GLL: Geographic position, latitude/longitude

VHW: Water speed and heading

VBW: Dual ground/water speed

HVE: GPS antenna up-down motion amplitude (FURUNO proprietary sentence)

ZDA: Time and date

RMC: Recommended minimum specific GNSS data

OFF

ON

7.Use the Omnipad to choose OFF or ON as appropriate and then press the [ENT] key. Sentences selected for output are marked with an asterisk.

8.Repeat steps 6 and 7 for other items. All sentences cannot be selected. The message “SENTENCE OVERLOAD” appears when too many sentences have been selected. Change settings as appropriate. For further information see page 2-12.

9.Press the [MENU] key to return to the DATA OUT1 menu.

10.Choose BAUD RATE and then press the [ENT] key.

4800BPS

9600BPS

19200BPS

38400BPS

Baud rate options

2-10