Gaggenau rc 462/413 rf 411/413 rf 461/463 rf 471 rw 414/464 Aligning the appliance in the niche

2.Aligning the appliance in the niche

Note:

To ensure that the appliance functions correctly, it must be set perfectly levelled.

Depth alignment

The positioning aid on the door have been designed for the following total thickness of door panels:

–3/4" (19 mm)

–11/2" (38 mm)

Always take account of the possible differing thickness of the panel fronts which are to be fitted subsequently.

1.Align the appliance with the cabinet fronts using the positioning aid.

Place level over the positioning aid on the door.

The mark (a) attached at the appliance base is used as a standard gage for height adjustment. When adjusting the height, align this mark at a height of 11/2" (32 mm) above the floor.

It is very important to comply with this dimension for the subsequent alignment of the furniture fronts.

The height adjustment gauge (b) is used to set this height correctly. The upper edge of the gauge must be in alignment with the mark on the appliance.

2.Unscrew the feet at the front of the appliance until the mark (a) on the appliance is in alignment with the upper edge of the height adjustment gauge (b).

3.Align the appliance vertically using the feet at the back. Use a level!

Height alignment

Notes:

–Do not twist or jam the appliance inside the installation niche! When adjusting the height- adjustable feet, proceed gradually: Always alternate between left and right, etc.

–For easier adjustment of the rear feet take the weight off by slightly tilting the appliance forward.

–When using a wooden beam as an alternative anti-tip mechanism, turn the appliance as far as it will go against the wooden beam. Do not bend against the wooden beam.

The height-adjustable feet at the front and rear can all be adjusted from the front.

Front:	with open-ended wrench 1/ "
	(Width across flats 13 mm)	2
Rear:	with 5/16" (8 mm) hex nut driver via flexible
	shaft.

16