3. INSTALLATION
Installation and connecting the charging station
1.Position the charging station in a suitable spot.
2.Connect the low voltage cable to the charging station.
3.Connect the transformer’s power cable to a 230V wall socket. If the transformer is connected to wall socket outdoors, it must be approved for
outdoor use.
4.Attach the charging station to the ground using the supplied screws. Ensure the screws are screwed all the way down in the countersink.
IMPORTANT INFORMATION
It is not permitted to make new holes in the plate. Only the existing holes may be used to secure the plate to the ground.
IMPORTANT INFORMATION
Do not tread or walk on the charging station plate.
3.3 Charging the battery
As soon as the charging station is connected, it is possible to charge the mower.
The mower can be charged as soon as the charging station is connected. Set the main switch to the
1position.
Place R40Li in the charging station to charge the battery while the boundary and guide wires are being laid.
If the battery is flat, it takes around 80 to 100 minutes to fully charge it.
IMPORTANT INFORMATION
R40Li cannot be used before the installation is complete.
English - 19