3. INSTALLATION
Boundaries for the working area
If a high obstacle, for example a wall or fence, borders the working area, the boundary wire should be laid 30 cm from the obstacle. This will prevent R40Li from colliding with the obstacle and reduce body wear.
About 20 cm around the fixed obstacle will not be mown.
If the working area borders against a small ditch, for example, a flower bed or a small elevation, e.g. a low verge (3 - 5 cm), the boundary wire should be laid 20 cm inside the working area. This prevents the wheels from driving into the ditch or up onto the verge.
About 12 cm of grass along the ditch/stone edging will not be mown.
If the working area borders against a flat path or the like that lies level with the lawn, it is possible to allow R40Li to run a little over the path. The boundary wire should then be laid 5 cm from the edge of the path.
All the grass along the side of the pavement will be cut.
When the working area is divided by a flat slab path that is level with the lawn, it is possible to allow R40Li to run over the path. It can be an advantage to lay the boundary wire under the slabs. The boundary wire can also be laid in the joint between the slabs.
Note! The R40Li must never run over gravel, mulch or similar material which can damage the blades.
IMPORTANT INFORMATION
If the working area is adjacent to water bodies, slopes, precipices or a public road, the boundary wire must be supplemented with a fence or the like. The height must then be at least 15 cm. This will prevent R40Li from ending up outside the working area under any circumstances.
Min. |
15cm |
English - 21 |
