Gateway E3400 Command.com file

Error Message	Solutions
Diskette drive reset failed.	Enter the BIOS Setup utility, then make sure
	of the diskette drive parameters.
	Check the diskette drive cables. Make sure
	Pin 1 on the cable aligns with Pin 1 on the
	connector.
Diskette read failed - press F1	Make sure the boot disk contains the
to retry boot.	Command.com file.
	Use the configuration utility (if applicable) to
	make sure of your drive or controller
	configuration.
	Press F1 to restart the computer.
Gate A20 failure.	You may have an XT keyboard connected to
	an AT system or vice versa. Make sure the
	keyboard is configured to work with the
	appropriate system. Some keyboards have a
	switch to select either AT or XT.
Hard disk controller failure.	Make sure the hard drive cable is properly
	connected.
	Open the BIOS Setup utility program, then
	make sure that the correct drive type is
	selected.
Hard disk controller failure -	The drive controller may be defective. Press F1
press F1 to try reboot.	to try to restart the computer.
	Try running Fdisk and DOS Format. For more
	information, refer to your operating system
	documentation.
Insert bootable media device.	See “The IDE drive is not recognized by the
	system.” on page 85 for possible solution.
	See “The SCSI drive is not recognized by the
	system.” on page 85 for possible solution.
	Backup your files as soon as possible.
Insufficient disk space.	Check the free space on the disk volume. If the
	volume is full or almost full, remove
	unnecessary files. See “Hard drive
	management practices” on page 72.
Invalid configuration	Enter the BIOS Setup utility, then make sure
information…	of the parameter values.

98Troubleshooting