
The diskette drive will not read, write, or format.
Probable Cause | Solution |
|
|
The diskette is not | Make sure the diskette you are trying to format |
is | |
|
|
The diskette is corrupted. | Run ScanDisk, or a similar program, on the |
| diskette. If errors are detected and corrected, |
| try accessing the diskette again. |
|
|
The diskette is | Make sure the |
| (unprotected). |
|
|
The diskette drive LED illuminates continuously.
Probable Cause | Solution |
|
|
The diskette is corrupted. | Remove the diskette from the drive. If the light |
| remains on, try restarting the system. |
|
|
The cable to the drive is not | Open the system and check the cable between |
connected properly. | the diskette drive and its controller. Make sure |
| the pins are not bent or misaligned. |
|
|
An adapter card is not recognized by the system.
Probable Cause | Solution |
|
|
The interrupt or I/O address | Check the address configuration of the adapter |
is set incorrectly. | card and make sure that it does not conflict |
| with another card in the system. |
|
|
The card was not configured | Configure the card with the appropriate |
through the software. | software. |
|
|
The card was not installed | Reseat the card and make sure that its |
correctly. | jumpers are configured appropriately. |
|
|
Peripheral/adapter problems | 89 |