GBC F - 160 Figure 6.2.6 Tack leading edge, Press, f)Press STOP, g)Press FWD s, h)Push the leading edge of the precoated board up to the nip of the main rolls

Applications F - 160 Operation and Maintenance Manual

d)From the center, use one finger to tack down the leading edge of the image to the leading edge of the precoated board. Refer to Figure 6.2.6

f)Press STOP.

00.0 G O

F W R

INFORMATION

The leading edge is the first part of the

board or image that enters the nip of the rollers.

S P E E DREV.

S

S A F E T Y

g)Press FWD s.

Figure 6.2.6 Tack leading edge

00.0 G O

F W R

S P E E DREV.

S T O P

S A F E T Y

INFORMATION

Avoid tacking at the ends first and pressing towards the center, you may create a tunnel once you have reached the center. This will make for a difficult mounting application.

e)Set the precoated board with the image tacked to it in the center of the front infeed table.

h)Push the leading edge of the precoated board up to the nip of the main rolls.

WARNING

When operating the laminator using the variable speed footswitch, keep hands and fingers away from the nip of the rollers. Yo u ma y b e CRUSHE D o r BURNED!

i)Using the variable speed footswitch, slowly work the precoated board into the nip of the rollers. Stop just before the end of the tacked down section of the image enters the nip.

Page 6 - 14 © GBC Pro - Tech August 1999