GBC F - 160 manual 116

F - 160 Operation and Maintenance Manual Applications

g)Once the roll of laminate is on the upper unwind shaft, swing the upper unwind shaft back into the saddle.

CAUTION

Ensure the roll of laminate is loaded properly on the unwind shaft.

Exposed adhesive should be facing away from the rollers.

This will prevent hours of roll cleaning!

h)Push the clevis pin back down to secure the unwind shaft in its saddle.

i)Leave the safety shield in the up position.

j)Lift the clevis pin located in the saddle of the lower unwind shaft.

Saddle

Clevis pin

k)Swing the lower unwind shaft out enough to slide the roll of craft paper over the core chucks on the lower unwind shaft. Refer to Figure 6.4.2

INFORMATION

Twisting the roll of craft paper while sliding makes loading the film onto the unwind shaft easier.

l)Once the roll of craft paper is on the lower unwind shaft, swing the lower unwind shaft back into the saddle.

INFORMATION

The roll of craft paper has no preference to

side since both sides are the same.

m)Push the clevis pin back down to secure the unwind shaft in its saddle.

n)Center the upper roll and the lower roll of material on the unwind shafts. You may refer to your measurement chart in Section 5.3.2

Loading film ( Figure 5.3.4 )

INFORMATION

For the lower unwind shaft, add 1/4 in. to

th e measurement.

© GBC Pro - Tech August 1999 Page 6 - 27