GBC F - 160 Figure 6.5.2 Unwind shaft

Applications F - 160 Operation and Maintenance Manual

Figure 6.5.2 Unwind shaft

Saddle Clevis pin

	Roll of
Core support	laminate

Brake adjust	Core chucks
knob

g)Once the roll of laminate is on the upper unwind shaft, swing the upper unwind shaft back into the saddle.

CAUTION

Ensure the roll of laminate is loaded properly on the unwind shaft.

Exposed adhesive should be facing away from the rollers.

This will prevent hours of roll cleaning!

h)Push the clevis pin back down to secure the unwind shaft in its saddle.

i)Leave the safety shield in the up position.

j)Lift the clevis pin located in the saddle of the lower unwind shaft.

Saddle

Clevis pin

k)Swing the lower unwind shaft out enough to slide the roll of mount adhesive over the core chucks on the lower unwind shaft. Refer to

Figure 6.5.2

INFORMATION

Twisting the roll of mount adhesive while sliding makes loading the film onto the unwind shaft easier.

l)Once the roll of mount adhesive is on the lower unwind shaft, swing the lower unwind shaft back into the saddle.

CAUTION

Ensure the roll of mount adhesive is loaded properly on the unwind shaft.

Exposed adhesive should be facing away from the rollers.

This will prevent hours of roll cleaning!

Page 6 - 36 © GBC Pro - Tech August 1999