GBC F - 160 Figure 6.8.2 Unwind shaft

F - 160 Operation and Maintenance Manual Applications

h) Push the clevis pin back down to secure the unwind shaft in its saddle.

INFORMATION

Twisting the roll of laminate while sliding makes loading the film onto the unwind shaft easier.

i) Lift the clevis pin located in the saddle of the lower unwind shaft.

Figure 6.8.2 Unwind shaft

Saddle Clevis pin

Saddle

Clevis pin

	Roll of
Core support	laminate

Brake adjust	Core chucks
knob

j)Swing the lower unwind shaft out enough to slide the roll of mount adhesive over the core chucks on the lower unwind shaft. Refer to

Figure 6.8.2

g)Once the roll of thermal laminate is on the upper

unwind shaft, swing the upper unwind shaft	INFORMATION
back into the saddle.

Twisting the roll of mount adhesive while sliding makes loading the film onto the unwind shaft easier.

CAUTION

Ensure the roll of laminate is loaded properly on the unwind shaft.

Exposed adhesive should be facing away from the rollers.

This will prevent hours of roll cleaning!

k)Once the roll of mount adhesive is on the lower unwind shaft, swing the lower unwind shaft back into the saddle.

© GBC Pro - Tech August 1999 Page 6 - 71