Clock
To set the clock
Power failure
Oven Control, Clock & Timer
Wall Oven
The clock must be set for the automatic oven timing functions to work properly.
The time of day clock cannot be changed during Delay Start. (It can be changed during a regular bake or broil operation.)
1Press the CLOCK ON/OFF pad.
2 Press the number pads the same way you read them. For example, to set 12:34, press the number pads 1, 2, 3 and 4 in that order.
If number pads are not pressed within one minute after you press the CLOCK ON/OFF pad, the display reverts to the original setting. If this happens, press the CLOCK ON/OFF pad and reenter the time of day.
3Press the START pad. This enters the time and starts the clock.
To check the time of day when the display is showing other information, simply press the CLOCK ON/OFF pad. The time of day shows until another pad is pressed.
If a flashing time of day is in the display, | To reset the clock, press the CLOCK ON/OFF |
you have experienced a power failure. Reset | pad. Enter the correct time of day by pressing |
the clock. | the appropriate number pads. Press the |
| START pad. |
Timer
NOTE: The timer is independent of all the other functions and it does not control the oven. The CLEAR/OFF pad does not affect the timer.
You may program the timer to time cooking or other household activities for up to 9 hours and 59 minutes.
The timer counts down in minutes, 1 minute at a time, until the last 60 seconds are reached. Then the control will beep one time. The seconds will not be displayed until the last minute is reached.
When the timer reaches “ :00,” the control will beep 3 times followed by one beep every 6 seconds until the KITCHEN TIMER ON/OFF pad is pressed.
The 6 second tone can be canceled by following the steps in the Special Features of Your Control under Tones at the End of a Timed Cycle.
8
