Handset Sound Signals
Signal | Meaning |
A long warbling tone (with ringer on) | Signals an incoming call |
Three short beeps | Page signal |
One short beep (every 7 seconds) | Low battery warning |
Troubleshooting Guide |
|
Caller ID Solutions
No display
•Fully charge (for 16 hours) or replace the battery.
•If you are using AC (electrical) power, make sure that the unit is connected to a non- switched electrical outlet. Unplug the AC power converter from the unit and plug it back in.
Caller ID Error Message
•The unit displays this message if it detects anything other than valid Caller ID information during the silent period after the first ring. This message indicates the presence of noise on the line.
No Caller ID
•In order to receive Caller ID information, you must subscribe to the standard name/ number Caller ID service from your local telephone company.
Telephone Solutions
No dial tone
•Check and repeat installation steps:
Ensure the base power cord is connected to a working outlet .
Ensure the telephone line cord is connected to the base and the wall jack.
•Disconnect the base from the wall phone jack and connect another phone to the same jack. If there is no dial tone on the second phone, the problem might be your wiring or local service.
•The cordless handset may be out of range of the base. Move closer to the base.
•Ensure the battery is properly charged (16 hours).
•Ensure the battery pack is installed correctly.
•Did the handset beep when you pressed the TALK/LINE1/flash1 or TALK/LINE2/flash2 or handsfree button? The battery may need to be charged.
46
