GE 800 normally open or closed

normally open or closed. Press Clear twice to return to the INPUT Menu.

6.2.8. Press Clear to return to the MAIN MENU.

The analyzer will function as described in the Operation and Service Manual. When the switch is activated, and binary/digital signal is received, the analyzer will convert to a PAUSED mode. This will be noted on the MEASUREMENT DISPLAY screen.

GE Analytical Instruments, Inc. ♥2005H	Page 16 of 16	DIN 30001 Rev. E
		TOC,FLOW SWITCH UPGRADE 2.12CBI

Contents

3.Materials and Tools: 7/16" open end or adjustable wrench 1/2" open end wrench Flat head screwdriver Phillips head screwdriver Scriber Teflon→ tape WARNINGS: FIGURE ONE: FIGURE TWO: TC ZERO CORRECTION ENT = SAVE CHAR/NUM CLR = RESTART/EXIT ARROWS = CHANGE CHAR FACTORYACCESSV 5.2.10.REAGENT FLUSH is not a consumable to record 5.2.11.Print or record Errors and Warnings if desired 5.3.Replace the EPROM chip (IC chip) CAUTION: 5.3.1.Turn off the analyzer power and disconnect the power cord 2.12CBI NOTCH carrier, gently press the pins of the chip to conform to the carrier Be sure the NOTCH of the EPROM chip is toward the bottom of the analyzer and all the pins are engaged into the socket. Improper or forced installation will cause irreversible damage to the chip If the chip and carrier are not properly installed, a blank blue screen will ANALOG # RAW DATA COND ZERO FIGURE EIGHT: FACTORY ACCESS Menu FIGURE EIGHT FIGURE TEN 5.7.3.From the SETUP menu, choose SAMPLE MODE 5.7.5.1.From SETUP, select 50/60HZ 5.7.5.2.Select the appropriate Frequency for the analyzer 5.7.6.Reset Acid/Oxidizer/UV Lamp/Pump Tubing dates and percentages 5.7.6.1.Select CONSUMABLES from the MAIN Menu, press Enter CONSTANT VALUE CONSTANT VALUE AFTER CONSTANT VALUE PRIOR NAME UPGRADE Page Page START TOC SETUP HISTORY CALIBRATE ERRORS DIGITAL INP. POLARITY RUN WHEN: OPEN CHANGE TO: CLOSED ARROWS TO CHANGE ENT = SET FIGURE SIXTEEN: normally open or closed