GE Adora 29, Profile 26 and 29 REPLACING THE REFRIGERATOR DOORS, 7REMOVE THE FREEZER DOOR, the rail system. (See page 19.), APull the freezer door open to full extension

Installation Instructions

6

D

E

F

G

H

REPLACING THE REFRIGERATOR DOORS

(cont.)

Insert the top hinge pin into the hinge hole on top of the refrigerator door. Make sure the door is aligned with the cabinet and opposite door. Attach the hinge to the top of the cabinet. Do not tighten bolts completely.

On left-hand doors, pass the wires and water line through the top hinge pin. Then connect the water line and door electrical connector.

Attach the ground wire with a Phillips-head screwdriver at the right and left hinge.

Make sure the gasket on the door is flush against the cabinet and is not folded. Make sure the door is straight and the gap between the doors is even across the front. While holding the aligned door in place, tighten the top hinge bolts.

Reconnect all connectors at the left and right sides of the top cap. Reattach the three Phillips-head screws on top.

Ground

Wire

29

7REMOVE THE FREEZER DOORAPull the freezer door open to full extension.

BRemove the freezer bin by pulling both brackets upward at the same time. (See page 19.)

CTake out the lower basket by lifting the basket up fromthe rail system. (See page 19.)DRemove the two 10 mm hex-head bolts from the right and left side.