Cool Mode
Use the Cool mode at Low, Med, High or Auto Fan Speed for cooling. Use the Temperature Increase ▲
/Decrease ▼ pads to set the desired temperature between 64°F and 86°F in 1°F increments.
An electronic thermostat is used to maintain the room temperature. The compressor will cycle on
and off to keep the room at the set level of comfort. Set the thermostat at a lower number and the indoor air will become cooler. Set the thermostat at a higher number and the indoor air will become warmer.
NOTE: If the air conditioner is off and is then turned on while set to a Cool setting or if turned from a fan setting to a Cool setting, it may take approximately
3 minutes for the compressor to start and cooling to begin.
Energy Saver Mode
Controls the fan.
compressor. This results in wider variations of room temperature and humidity. Normally used when the
room is unoccupied. NOTE: The fan may continue to run for a short time after the compressor cycles off.
GEAppliances.com
Cooling Descriptions
For Normal
For Maximum
For Quieter and Nighttime
cycles on and off.
Safety Instructions Operating Instructions Care and Cleaning
Fan Only Mode
Use the Fan Only Mode at Low, Med or High fan | NOTE: Auto Fan Speed cannot be used when in the |
speed to provide air circulation and filtering without | Fan Only Mode. |
cooling. Since |
|
cooling, a Set temperature cannot be entered. The |
|
room temperature will appear |
|
in the display. |
|
Auto Fan Speed
Set to Auto fan speed for the fan speed to | NOTE: Auto Fan Speed cannot be used when in the |
automatically set to the speed needed to provide | Fan Only Mode. |
optimum comfort settings with the set temperature. |
|
If the room needs more cooling, the fan speed |
|
will automatically increase. If the room needs less |
|
cooling, the fan speed will automatically decrease. |
|
Remote Control
n | To ensure proper operation, aim the remote | n | Make sure nothing is between the air conditioner |
| control at the signal receiver on the air |
| and the remote control that could block the |
| conditioner. |
| signal. |
n | The remote control signal has a range of | n | Make sure batteries are fresh and installed |
| up to 20 feet. |
| correctly as indicated on the remote control. |
Installation Instructions Troubleshooting Tips
5