Note
The system will not accept the same code for two differ- ent users. To change Sys- tem and Partition Master codes please see Appendix
C:“Using Programming Menus”.
If more than 40 keys are pressed when the system asks for a code, and those keystrokes are not part of a valid access code, a siren will sound. Talk to your installer or see Appendix A “Touch- pad Information” on page 44 to see if this feature is enabled.
Changing or Erasing User Codes
A Touchtone phone can be used to change or erase user codes, but alphanumeric or fixed display touchpads work much better because of their extensive feedback. See Appendix C for phone pro- gramming instructions.
Changing a User Code
To change or assign a user code:
1.Enter the programming menus by pressing 9 + System or Partition Master CODE.
2.For Concord 4 systems, press 030 nnn 0 where nnn is the user 000 through 229.
For Concord Express V4 systems, press 030 nn 0 where nn is the user 00 through 15.
3.Enter the desired
4.Press * + 00 + # to exit the programming menus.
Deleting a User Code
When a code is deleted, it can no longer operate the system.
To delete a user code:
1.Enter the programming menus by pressing 9 + System or Partition Master CODE.
2.For Concord 4 systems, press 030 nnn 0 where nnn is user 000 through 229.
For Concord Express V4 systems, press 030 nn 0 where nn is the user 00 through 15.
3.Enter the System or Partition Master CODE, then #.
4.Press * + 00 + # to exit the programming menus.
Assigning Code Attributes
Code attributes determine the limits or capabilities of a code. You will want certain users to have more control over the system than others. For example, you would want an adult to have more control over the system than a child. Below are code attributes that you can assign.
Assigning the Direct Bypassing Attribute
This attribute allows the user to bypass open sensors. If the user code does not have this attribute turned on, the code restricts the user from bypassing sensors directly.
To assign Direct Bypassing to a user:
1.Enter the programming menus by pressing 9 + System or Partition Master CODE.
2.For Concord 4 systems, press 030 nnn 1 where nnn is user 000 through 229.
For Concord Express V4 systems, press 030 nn 1 where nn is the user 00 through 15.
3.To turn Direct Bypassing: on, press 2 + #.
off, press 1 + #.
4.Press * + 00 + # to exit the programming menus.
Assigning the Remote Access Attribute
This attribute allows the user to access the security system from a telephone outside the protected premises. If the user code does not have this attribute turned on, the code restricts user from remote telephone access.
To assign Remote Access to a user:
1. Enter the programming menus by pressing 9 + System or Partition Master CODE.
14 | Concord 4 Series Security Systems |
