GE Concord 4 manual Activating a Police Panic Alarm

	Step 2. Enter the command.
Disarm the system	# + 1 + CODE
Arm to Level 2*	# + 2 + CODE
Arm to Level 3*	# + 3 + CODE
Send a Police panic alarm	* + * + * + * + * + *
	(Available from on-site only.)
Arm system with No Delay*	# + 2 + CODE + 4 or
	# + 3 + CODE + 4
Arm to enable Latchkey*	# + 2 + CODE + 6 or
	# + 3 + CODE + 6
Arm system with exit lights off*	# + 2 + CODE + 0 or
	# + 3 + CODE + 0
Bypass a sensor	Indirectly: Arm system + # + #
	Directly: # + # + CODE + Sensor Number
Arm silently*	# + 5 + 2 + CODE or
	# + 5 + 3 + CODE
Turn all lights on/off	# + 0 + 0
Turn specific lights on/off	# + 0 + Light number (1–9)
Cancel an accidental alarm	# + 1 + CODE or # + CODE
Check the system status	# + * for short status
	# + ** for full status
Turn Chime on/off	# + 7 + 1
Turn Energy Saver on/off	# + 7 + 2
Disable local phone access	# + 7 + 3 (on-site only) or
	Wait 5 seconds after picking up a local phone.
Check alarm memory	# + 7 + 6
Activate Outputs	# + 7 + 7 + Output number (1–6)

* If Quick Arm feature is on, access code is not required. See page 6 for more information.

Activating a Police Panic Alarm

Your system can be set up so you can activate a Police panic alarm from an on-site Touchtone phone. If your system is set up for this:

•Press the * repeatedly, regardless of your phone command prefix key.

•Do not wait more than two seconds between key presses. Continue pressing * even if you hear the system voice interrupt with a system status.

Off-site Touchtone phones cannot activate this alarm.

36 Concord 4 Series Security Systems