Turning on the water heater.
Safety | Instructions |
Operating | Instructions |
Care and | Cleaning |
The first time you press the power button and the water heater is powered on, the screen will ask for confirmation that the tank has been filled with water. The tank must be full of water before the heater is turned on to prevent damage.
The water heater warranty does not cover damage or failure resulting from operation with an empty or partially empty tank. (Refer to the Certificate of Limited Warranty for complete terms and conditions.)
If the tank has NOT been filled, vent and fill tank with water before pressing the POWER button again.
•Make sure the drain valve is completely closed.
•Open the
•Open each hot water faucet slowly to allow the air to vent from the water heater and piping.
•A steady flow of water from the hot water faucet(s) indicates a full water heater.
After the tank has been filled with water, press the POWER button again.
Installation | Instructions |
Troubleshooting | Tips |
Consumer | Support |
Once the water heater has been powered on, the | To comply with safety regulations, the controls are |
main screen will be shown. The display will show | factory preset to 120°F and Hybrid Mode. These are |
the current water temperature setting and the | the recommended settings for the water heater. |
current operating mode for the water heater. |
|
If the display goes blank, press any key to reactivate the display. To go back to the default (HOME) screen, press the left arrow button until the default (HOME) screen appears.
6