USER INTERFACES

4. USER INTERFACES

4.1.SOFTWARE

CIO units need to be connected to a master unit, either an F650 or an F600. If the master unit is an F650, the CIO can be programmed using EnerVista F650Setup program; in case of using an F600 as master unit, the CIO can be programmed using GE-CONF software. In both cases, CIO inputs/outputs will be shown as if they were part of the master unit, with the same programming options as the master unit I/O.

EnerVista F650Setup software provides a simple way to configure, monitor and maintain operation of F650 and the connected CIO unit. Please refer to the F650 user manual for a more detailed reference about EnerVista F650Setup.

In the same way, please refer to GE-CONF software manual for details about programming a CIO unit connected to an F600 master unit.

4.2.FRONT INDICATORS

CIO units incorporate 2 LEDs on the front, one of them indicates that the unit is powered, and the other indicates activity on the CAN bus.

GEK-106465A

CIO Remote CAN Digital I/O Module

29

Page 30
Image 30
GE GEK-106465A instruction manual Software, Front Indicators