I/O MODULES DESCRIPTION
Contact Outputs activation signals:
These are the signals that mark the physical activation of contact outputs, independently from their associated logic. They can be obtained at Actual > Status > Contact Outputs > Board X, being X the corresponding I/O board. The output name is the same both for the mixed and supervision boards; the difference will be the symbol associated to the slot where the board is located in the unit (slot F, G, H or J).
TABLE
CONTACT OUTPUT STATUS
(X: board F, G, H, J)
CONT OP_X_01
CONT OP_X_02
CONT OP_X_03
CONT OP_X_04
CONT OP_X_05
CONT OP_X_06
CONT OP_X_07
CONT OP_X_08
Contact Output Activation Signals (Contact Output Operates):
These are the logic signals associated to contact outputs that produce their activation. Actual > Status > Contact Outputs Operates > Board X, being X the corresponding I/O board. The name of these outputs is the same for the mixed and supervision boards, the only difference will be the slot where the output is located in the relay (slot F, G, H or J). These signals can be configured at Setpoint > Relay Configuration > Outputs > Contact Output Operate.
TABLE
CONTACT OUTPUT
OPERATES
(X: board F, G, H, J)
CONT OP OPER_X_01
CONT OP OPER_X_02
CONT OP OPER_X_03
CONT OP OPER_X_04
CONT OP OPER_X_05
CONT OP OPER_X_06
CONT OP OPER_X_07
CONT OP OPER_X_08
CIO Remote CAN Digital I/O Module | 37 |
