I/O MODULES DESCRIPTION

Contact Output Reset Signals (Contact Output Resets):

These are the logic signals associated to the contact output reset, which produce the reset of those signals previously configured as Latched. The status of these signals is obtained at Actual > Status > Contact Outputs Resets > Board X, being X the corresponding I/O board. The name of these outputs is the same for the mixed and supervision boards, the only difference will be the slot where the output is located in the relay (slot F, G, H or J). These signals can be configured at Setpoint > Relay Configuration > Outputs > Contact Output Reset

TABLE 5-5 CONTACT OUTPUT RESETS

CONTACT OUTPUT RESETS

(X: board F, G, H, J)

CONT OP RESET_X_01

CONT OP RESET_X_02

CONT OP RESET_X_03

CONT OP RESET_X_04

CONT OP RESET_X_05

CONT OP RESET_X_06

CONT OP RESET_X_07

CONT OP RESET_X_08

IO Board Status:

These signals are associated to the different I/O boards. There are internal signals that provide information about the status of these boards, indicating whether there is any anomaly in the board, or whether the board is not available in the relay according to the relay model. This information can be accessed at Actual > Status > IO Board Status.

TABLE 5-6 I/O BOARD STATUS

BOARD STATUS

BOARD F STATUS

BOARD G STATUS

BOARD H STATUS

BOARD J STATUS

38

CIO Remote CAN Digital I/O Module

GEK-106465A

Page 39
Image 39
GE GEK-106465A instruction manual Contact Output Reset Signals Contact Output Resets, IO Board Status