GE HC HP - page 20

GE MDS Intrep id-HC HP Installation G uide
1-14
Important: The diameter of the pole upon which the kit is mounted must be between 50 mm (2") and
125 mm (5").
2. Connect shorts and 50 ohm terminations on all OCBs (shorts on main antenna por ts, 50 ohm termina tions on
diversity antenna ports).
3. Assemble both couplers on the OCBs.
4. Attach the hanging bracket to the OCBs and tighten the screw s that fasten the OCB to the hanging-bracket.
5. Gently lift the assembled unit to the pole using the lifting handle.
6. Place the assembled units on the pole mount clamp bracket and faste n the M10 screws, as shown in the
following illustration.
7. Connect the XPIC cables between the units, as shown in the following illustration.
M10 Screws used
to Fasten the Units
to the Pole Mount
Clamp