PAGE 12 | 06 Apr 2000 | CH. 1: INTRODUCTION |
|
|
|
1.4Upgrade Revision Software & Firmware
1.4.1Scope
To avail of any new features that are included in this new release on units that were purchased previous to this release, both software and firmware require updating by the user. Any new unit will be
1.4.2Software Upgrade
To update the software requires that the user install the new version of software from the installation CD. You may install the new software over any previous version installed. See section 1.4 Software Installation Instructions.
To update existing projects simple open the project from the newly installed version of the software. Once the project is saved to disk the update is complete. For backup reasons we recommend that you save the new version of your project in a different location or under a different file name.
1.4.3Firmware Upgrade
The following steps assume that a project or configuration is loaded to the Operator Station and that the user is running the latest version of software.
a)Upload the project/configuration from the unit.
b)If a customised character set is loaded to the unit then upload the character set also.
c)Choose Automation Device from main menu Configure/Communication Settings.
d)From File menu choose Update TIU Operating System. (See Updating Operating System for more details).
e)From File menu choose Update TIU Protocol. If you are updating from firmware version 2.00 or later then you just have to update to the latest protocol file. However if you are updating from firmware version 1.24 or earlier you most update to a Upgrade.1xx protocol file first, then update to the latest firmware revision. See Note. (See updating protocol for further information).
f)Choose Download Character Sets to TIU from File menu.
g)Choose Download Project to TIU from File menu.
Note: When updating the protocol file the screen may go blank after the protocol file is complete. Continue with the procedure as described and the display will recover.
