Installation of the range.

Read these instructions completely and carefully.

IN THE COMMONWEALTH OF MASSACHUSETTS

This product must be installed by a licensed plumber or gas fitter.

When using ball type gas shut-off valves, they shall be the T-handle type.

A flexible gas connector, when used, must not exceed 3 feet.

BEFORE YOU BEGIN

Installation of this range must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA.54, latest edition. This range has been design-certified by CSA International according to ANSI Z21.1, latest edition.

Safety Instructions Operating Instructions

As with any appliance using gas and generating heat, there are certain safety precautions you should follow. You will find these precautions in the Important Safety Information section in the front of this manual. Read them carefully.

IMPORTANT: OBSERVE ALL GOVERNING CODES AND ORDINANCES.

NOTE: This appliance must be properly grounded.

IMPORTANT: Save these instructions for the local electrical inspector’s use.

NOTE TO INSTALLER: Leave these instructions with the appliance after installation is completed.

NOTE TO CONSUMER: Keep this Owner’s Manual and Installation Instructions for future use.

SERVICER: The electrical diagram is in an envelope attached to the back of the range.

Installation

FOR YOUR SAFETY

Do not store or use combustible materials, gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance.

If you smell gas:

Open windows.

Extinguish any open flame.

 

Don’t touch electrical switches.

 

Immediately call your gas supplier.

ELECTRICAL REQUIREMENTS

CAUTION: FOR PERSONAL SAFETY,

Wiring must conform to National Electric Codes.

DO NOT USE AN EXTENSION CORD WITH THIS

If the electric service provided does not meet the

APPLIANCE. REMOVE HOUSE FUSE OR OPEN CIRCUIT

Instructions Troubleshooting Tips

BREAKER BEFORE BEGINNING INSTALLATION.

above specifications, have a licensed electrician install an approved outlet.

This appliance must be supplied with the proper

voltage and frequency, and connected to an

Because range terminals are not accessible after range is in position, flexible service conduit or cord

individual, properly grounded circuit, protected

by a circuit breaker or time-delay fuse, as noted on the rating plate.

must be used.

39

Consumer Support

Page 39
Image 39
GE J2B918 Installation of the range, Safety Instructions Operating Instructions, Instructions Troubleshooting Tips