Installation of the range.

Install the Anti-Tip Device

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include all necessary information to complete the installation. Read the Safety Instructions and the instructions that fit your situation before beginning installation.

Bracket

Wall plate

Screw must enter wood or metal

Typical installation of anti-tip bracket attachment to wall.

WARNING:

Range must be secured by Anti-Tip bracket supplied.

If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti-Tip device WB2X7909.

See instructions to install (supplied with bracket).

Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury might result from spilled hot liquids or from the range itself.

Consumer Support Troubleshooting Tips Installation Instructions Operating Instructions Safety Instructions

When All Hookups Are Completed:

MAKE SURE ALL CONTROLS ARE LEFT IN THE

MAKE SURE THE FLOW OF COMBUSTION

OFF POSITION.

AND VENTILATION AIR TO THE RANGE IS

 

UNOBSTRUCTED.

Converting to LP Gas (or converting back to natural gas from LP)

This range leaves the factory set for use with natural gas.

The conversion instructions and LP orifices can

If you want to convert to LP gas, the conversion must be

be found attached to the range next to the

performed by a qualified LP gas installer.

pressure regulator.

 

Keep these instructions and the orifices in case

 

you want to convert back to natural gas.

52

Page 52
Image 52
GE J2B918 Install the Anti-Tip Device, When All Hookups Are Completed, Performed by a qualified LP gas installer