Read these instructions completely and carefully.

Replace the Power Cord (Optional) Continued

Perform this step only if the power cord shipped on the range does not match your wall receptacle.

Safety Instructions

4-Wire Conduit Installation Option

Remove the strain relief clamp from the bracket.

Assemble the squeeze connector (obtained locally), matching the diameter of your conduit, in the bracket hole. Insert the conduit through the squeeze connector. Allow enough slack to easily attach the wires to the terminal block.

NOTE: Do not install the conduit without a squeeze connector.

Insert the ground bare wire tip between the range frame and the ground plate (removed earlier) and secure it in place with the ground screw (removed earlier). Insert the bare wire (white/neutral) tip through the bottom center of the terminal block opening. Insert the two side bare wire tips into the lower left and the lower right terminal block openings. Tighten the screws until the wire is firmly secure (approximately 20 inch-lbs.).

NOTE: Make sure the wire is completely inserted into the terminal block and a secure connection is made.

Secure the squeeze connector in place in the bracket by tightening the squeeze connector screws.

Squeeze connector

Conduit

Terminal block

Wire tips

Ground screw

Bracket

Ground plate (grounding to range)

Bracket

Operating Instructions Installation Instructions

NOTE: ALUMINUM WIRING:

Aluminum building wire may be used but it must be rated for the correct amperage and voltage to make connection.

Wire used, location and enclosure

of splices, etc., must conform to good wiring practices and local codes.

Troubleshooting

Replace the Wire Cover

Replace the wire cover on the range back by sliding its right edge under the retaining tab and replacing the two screws removed earlier. Make sure that no wires are pinched between the cover and the range back.

2 screws to

Retaining tab

replace

 

wire cover

 

 

Wire

 

cover

Tips Consumer

Back of range

49

Support

Page 49
Image 49
GE J2B918 Tips Consumer, Replace the Wire Cover, Wire used, location and enclosure, Troubleshooting