GE JBP80 warranty How to Set the Controls, Cooking Guide for Using Heat Settings

At both OFF and HI the control ‘“clicks” into position.	Switching heats to higher settings always shows a
You may hear slight “clicking” sounds during cooking,	quicker change than switching to lower settings.
indicating the control is keeping the unit at the heat
level or power level you set.

E

o

How to Set the Controls

Push the knob in and turn in either direction to the &sired heat setting.

Y

Be sure you turn the control knob to OFF when you finish cooking.

The surface unit “on” indicator light will glow when ANY surface unit is on.

El

UQ

Cooking Guide for Using Heat Settings

HI—Usedto begin cooking or to bring water to a boil. Reduce heat setting after water boils.

Medium High-—(Setting halfway between HI and MED) Maintains a fast boil on large amounts of food.

MED—Saut6 and brown; keeps food at a medium boil.

Medium Low--–(Setting halfway between MED and LO) Cook after stinting at HI; cooks with little water in covered pan.

LO—Used for long slow cooking (simmering) to tenderize and develop flavors. Use this setting to melt butter and chocolate or to keep foods warm.

NOTE: The surface unit “on” indicator light may glow between LO and OF’F, but there is no power

to the surface units.

	LO	OFF	HI
	\l	/
	—
	i		–
			‘ k Medium
Medium	@ ‘
Low	‘m “			High
	i	\

//\

MED

Appearance may vary slightly.

Light Over the Surface Units

The switch must be pushed, held for several seconds	o
and released for the 1 ight to come on.
	E

Special Notes for Glass Cooktops:

Cooktop temperatures increase with the number of surface units that are on. With 3 or 4 units turned on, surface temperatures are high so be careful when touching the cooktop. The hot surface indicator light will remain lit after the surface unit is off until the surface is cool enough to touch.

NOTE:

●At HI und .Medi um High WII ings never leak e food unattended. Boi]ovel”s cause smoking and greasy spillovers may catch fire.

●When a surface unit is turned on, the unit can be seen glowing red within a few seconds (longer for radiant units). The red glow will turn on and off (cycling) tc> maintain the selected heat setting. With poor cookware, you will see frequent cycling of the unit off and on. Good, flat cookware will minimize the cycling. See the Surface Cookware Tips section.

. It is safe to place hot cookware from the oven or surface on the glass ceramic surface when it is cool.

(Continual }Ie.l”t page)

● At Medium Low and LO settings melt chocolate	13
and butter on u small surface unit.