GE JBP80 To Set the Clock, To Set the Timer, To Reset the Timer, End of Cycle Tones

Clock

The clock must be set for the automatic oven timing functions to work properly. The time of day cannot be changed during a Timed Baking or CLEAN cycle.

To Set the Clock

CLOCK

D ‘“’’’’’pad”(4!X7

2. Press the INCREASE or DECREASE pad to set the time of day. -

3. Press the CLOCK pad to start.

&

Timer

The timer is a minute timer; it does not control oven operations. The maximum setting on the timer is

9 hours and 55 minutes.

To Set the Timer

(—j 1. Press the TIMER pad.

TIMER

2.Press the INCREASE or DECREASE pad to set the amount of time on the timer.

The timer will start automatically within a few seconds of releasing the INCREASE or DECREASE pad.

The timer, as you are setting it, will display hours and minutes. “HR” will be in the display.

During the countdown, when the timer reaches the last minute, the display will change to seconds only and a single beep will sound.

1-

To Reset the Timer To Cancel the Timer

If both “SET” and “TIMER” are displayed, press the INCREASE or DECREASE pad until desired time is reached.

If only “TIMER” is displayed, press the TIMER pad first, then follow the instructions above to set the timer.

Press and hold the TIMER pad until the word “TIMER” disappears from the display.

End of Cycle Tones

The end of cycle tone is a series of 3 beeps followed by 1 beep every 6 seconds. If you would like to remove the signal that beeps every 6 seconds. press and hold the CLEAIVOFF pad for 10 seconds.

To return the signal that beeps every 6 seconds, press and hold the CLEAR/OFF pad for 10 seconds.

Power Outage

After a power outage, when power is restored, the display will flash and time shown will no longer be correct-for example, after a 5-minute power interruption the clock will be 5 minutes slow.

All other functions that were in operation when the power went out will have to be programmed again.

Display Messages

programmed information can be displayed at any time by pressing the pad of the operation you want to see. For example. you can display the current time of day while the timer is counting down by pressing the CLOCK pad. Press the TIMER pad to return to the timer display.

To check the start time for Delayed Bake or Self-Clean, press and hold the COOK TIME or AUTO SELF CLEAN pad for 3 seconds. The display will show the bake or clean start time for as long as you press the pad. When you release the pad, the display will return to the time of day.

If “door” appears in the display, LOCK flashes, and the oven control signals you set the self- clean cycle and did not shut the oven door.

(cotttinued next p(lge)

19

--