Instructions
Using the gas surface burners.
Throughout this manual, features and appearance may vary from your model.
Instructions Safety
Electric Ignition
Your surface burners are lit by electric ignition, eliminating the need for standing pilots with constantly burning flames.
In case of a power outage, you can light the surface burners on your cooktop with a match. Hold a lit match to the burner, then turn the control knob to the high position. Use extreme caution when lighting the burners this way.
Surface burners in use when an electrical power failure occurs will continue to operate normally.
IN CASE OF A POWER FAILURE, THE VENTILATION SYSTEM WILL NOT OPERATE. DO NOT USE THE GRILL MODULE OR GRIDDLE IF THE VENTILATION SYSTEM
IS NOT OPERATIONAL.Cleaning Operating
Push the control knob down and turn it to the LITE position.
How to Light a Gas Surface Burner
Push the control knob down and turn it to the LITE position.
You will hear a little clicking
After the burner ignites, turn the knob to adjust the flame size.
To turn a burner off, turn the knob clockwise, as far as it will go, to the OFF position.
If the flame is too low at the setting, the valve can be adjusted. Refer to Flames too
high or too low at the LOW setting in the Troubleshooting Tips section.
Tips Care and
How to Select Flame Size
For safe handling of cookware, never let the flames extend up the sides of the cookware.
Watch the flame, not the knob, as you reduce heat. The flame size on a gas burner should match the cookware you are using.
Any flame larger than the bottom of the cookware is wasted and only serves to heat the handle.
Troubleshooting
Before Lighting a Gas Burner
■ Make sure all grates on the cooktop | ■ Only surface burners may be used |
are in place before using any burner. | on the right side. |
Consumer Support
After Lighting a Gas Burner
■ Do not operate the burner for an extended period of time without cookware on the grate. The finish on the grate may chip without cookware to absorb the heat.
■ Check to be sure the burner you turn on is the one you want to use.
■ Be sure the burners and grates are cool before you place your hand, a pot holder, cleaning cloths or
■ When trying to simmer delicate |
foods, use the right side of the unit |
for best results. The LO setting on |
the left side is hotter to accommodate |
the grill module. If you find that the |
LO setting is too hot, you can adjust |
the valve. See the Troubleshooting Tips |
section. |
■ Do not allow large pans to extend |
over the control knobs. Heat trapped |
between large pans and control |
8
other materials on them.
knobs could cause possible damage |
to the control knobs. |
