GE JGSP20GER, JGSP21GER Problem Solver, If you need more help. ..call, toll free GE Answer Center

	PROBLEM SOLVER
	(continued)
PROBLEM	POSSIBLE CAUSE
CLOCK AND TIMER	● Make sure the electrical plug is plugged into a live, properly grounded
DO NOT WORK	power outlet.
	● Check for power outage.
	● Review Oven Control, Clock and Timer section.
OVEN NOT CLEAN	c Oven controls not set properly.
AFTER CLEAN CYCLE	* Heavily soiled ovens require 3’% to 4-hour clean time.
	● Heavy spillovers should be cleaned up before starting clean cycle.

STRONG ODOR	● Improper air/gas ratio in oven. Adjust oven burner air shutters. See Minor
	Adjustments YOU Can Make section.

●An odor from the instdation around the inside of the oven is normaI for the first few times oven is used, This is temporary.

OVEN LIGHT DOES	@ Bulb may be loose or burned out.
NOT COME ON	* Electrical plug must be plugged into a live power outlet.

●Switch operating oven light is broken. Call for service.

OVEN WILL NOT	● STOP TIME must be more than 3 hours later than START TIME.
SELF-CLEAN	# Oven temperature is too high to set self-clean operation. Allow the range to cool
	to room temperature and reset controls.

If you need more help. ..call, toll free:

GE Answer Center

CARE AND CLEANING

(continued)

:ept clean at all times nhampered flame.

inely, especially after lese holes. Burners

; screw was removed

>burners in place to during shipment. screw.

	Range Top Burners
	The holes in the burners must be
	for proper ignition and an even,
	You should clean the burners rol
	bad spillovers which could clog
	lift out for cleaning if the shippi]
	at installation.
	NOTE: A screw holds each of t]
o	keep them from wobbling aroun
!	Remove and discard the shippini
k

the right to In the burner

lbly, then pull e to free the air :e.

:the burners in

:and water. Soak ‘the food doesn’t rith soap and water use steel wool or

Remove Shipping Screw
A	Gas Valve
	Orifice
—
Q	T

u

-

g –~ – , ~ –J , \ s~+

———. —, -—~ —

.	Air Shutter
●
*

To replace burners:

1. Slip the air shutter over the gas valve orifice.

To remove burners:

1.Grasp burner head and tilt it t< release the two tabs from slotf support (A and B).

2.Lift the end of the burner asse away from the front of the ran shutter from the gas valve orif

To remove burned-on food, so:

a solution of mild liquid deterge] the burner for 20 to 30 minutes. rinse off completely, scrub them and a brush or plastic pad. Do nc