GE JGSP31, JGSP40, JGSP30 manual Dven Light Bulb, Removable Oven Bottom, To remove

Dven Light Bulb

The light bulb is located on the back oven wall.	~ Gasket
Before replacing the bulb, disconnect the electric
power to the range at the main fuse or circuit breaker
panel or unplug the range from the electric outlet.
Let the bulb cool completely before removing it.
Do not touch a hot bulb with a damp cloth. If you do,
the bulb will break.

TO REMOVE:

●Remove the 3 screws in the light cover.

●Detach the light cover and remove the bulb.

TO REPLACE:

●Put in a new 40-watt appliance bulb. NOTE: A 40-watt appliance bulb is smaller than a standard 40-watt household bulb.

●Install the light cover. Replace the 3 screws and tighten, making sure the cover fits flush with the oven wall.

●Reconnect the electric power to the range.

Removable Oven Bottom

“he oven bottom can be removed to clean large spills, and to enable you to reach the oven burner. The oven bottom must be replaced before using the self-clean cycle.

~c:~

/d

UnlockLock

To remove:

1.Slide the tab at the center front of the oven bottom to the left.

2.Lift the oven bottom up and out.

To replace:

1.Slip the oven bottom into the oven so the tabs in the rear of the oven bottom fit into the slots in the oven back.

2.Lower the front of the oven bottom into place and slide the front tab to the right to lock the oven bottom into place.

The oven bottom has a porcelain enamel finish. To make cleaning easier, protect the oven bottom from excessive spillovers. This is particularly important when baking a fruit pie or other foods with high acid content. Hot fruit fillings or foods that are acidic (such as milk, tomatoes or sauerkraut, and sauces with vinegar or lemon juice) may cause pitting and damage to the porcelain enamel surface.

To protect the oven bottom surface, place a piece of aluminum foil slightly larger than the baking dish or a small cookie sheet on a lower shelf or under the baking dish to catch any spillovers. It should not completely cover the shelf as this would cause uneven heat in the oven. Aluminum foil should not be placed on the oven bottom.

If a spillover does occur on the oven bottom, allow the oven to cool first. You can clean the oven bottom with soap and water, a mild abrasive cleanser or soap- filled abrasive pads. Rinse well to remove any soap before self-cleaning.

33