![OVEN CONTROL, CLOCK AND TIMER](/images/new-backgrounds/80943/8094321x1.webp)
OVEN CONTROL, CLOCK AND TIMER
;lock
The clock must be set for the automatic oven timing functions to work properly. The time of day cannot be changed during a Timed Bake or CLEAN cycle.
Timer
The timer is a minute timer only. The timer does not control oven operations. The maximum setting on the timer is
9 hours and 55 minutes.
To Set the Clock
1.Press the CLOCK
CLOCK pad.
D
To Set the Timer
1.Press the TIMER pad.
TIMER
c1
2.Press the INCREASE or DECREASE pad to set the amount of time on timer.
The timer will start automatically within a few seconds of releasing the pad.
2.Press the INCREASE
nA or DECREASE pad
~to set the time of day.
3.Press the CLOCK pad to start.
The timer, as you are setting it, will display seconds until 60 seconds is reached.
Then it will display minutes and seconds until 60 minutes is reached.
After 60 minutes, it will display hours (“HR” now appears in display) and minutes until the maximum time of 9 hours and 55 minutes is reached.
To Reset Timer
If “TIMER” is showing, press the INCREASE or DECREASE pad until the desired time is reached.
If “TIMER” is not showing, press the TIMER ON/OFF pad first, then follow instructions above to set the timer.
To Cancel Timer
Press the TIMER pad until the word “TIMER” quits flashing on the display (about 4 seconds).
Power Outage?
After a power outage, when power is restored, the display will flash and time shown will no longer be
The display flashes until the clock is reset. All other functions that were in operation when the power went out will have to be programmed again.
End of Cycle Tones
The end of cycle tone is 3 short beeps followed by 1 beep that repeats every 6 seconds until you press any operation. If you would like to eliminate the repeating beeps, press and hold the CLEAR/OFF pad for 10 seconds.
To return the end of cycle tone to the repeating beeps, press and hold the CLEAR/OFF pad for 10 seconds.
Display Messages
If “DOOr” appears on the display, the door is open. Close the door. If “LOCK” appears on the display, the oven door is in the locked position. BAKE, BROIL and COOK TIME cannot be set if the door is in the locked position.
11