
Installation Instructions
INSTALLING THE REFRIGERATOR
REFRIGERATOR LOCATION
•Do not install the refrigerator where the temperature will go below 60°F (16°C) because it will not run often enough to maintain proper temperatures.
•Do not install the refrigerator where the temperature will go above 100°F (37°C) because it will not perform properly.
•Install it on a floor strong enough to support it fully loaded.
CLEARANCES
Allow the following clearances for ease of installation, proper air circulation and plumbing and electrical connections.
Sides | 1/8″ (3 mm) |
Top | 1″ (25 mm) |
Back | 1″ (25 mm) |
REMOVING THE REFRIGERATOR DOORS
•IMPORTANT NOTE: This refrigerator is 355/8″ deep.
Doors and passageways leading to the installation location must be at least 36″ wide in order to leave the doors and handles attached to the refrigerator while transporting it into the installation location. If passageways are less than 36″ , the refrigerator doors and handles can easily be scratched and damaged. The top cap and doors can be removed to allow the refrigerator to be safely moved indoors. Start with Step 1.
•If it is not necessary to remove doors, skip to Step 9. Leave tape and all packaging on doors until the refrigerator is in the final location.
•NOTE: Use a padded hand truck to move this refrigerator. Place the refrigerator on the hand truck with a side against the truck. We strongly recommend that
TWO PEOPLE move and complete this installation.
1REMOVE THE FRESH FOOD DOOR HANDLE
Stainless steel:
AREMOVING THE DOOR
HANDLE: Loosen |
|
the set screws with |
|
the 3/32″ Allen | Badge |
wrench | |
and remove | A |
the handle. |
|
Mounting
Fasteners
Plastic handle:
AREMOVING
THE DOOR |
| |
HANDLE: Slide |
| |
the handle up |
| |
and off of | Badge | |
the mounting | ||
| ||
fasteners. |
| |
| A |
Mounting
Fasteners
NOTE: If the handle mounting fasteners need to be tightened or removed, use a
2REMOVE THE FREEZER DOOR HANDLE
Stainless steel and plastic handles:
ALoosen the set screws located on the underside
of the handle with the 1/8″ Allen wrench and remove the handle.
NOTE: If the handle mounting fasteners need to be tightened or removed, use a
A
26