GE PFSS6SMXSS Remove The Freezer Door, Replacing The Refrigerator Doors, cont, D E F G H, A B C D

Installation Instructions

6

D

E

F

G

H

REPLACING THE REFRIGERATOR DOORS

(cont.)

Insert the top hinge pin into the hinge hole on top

of the refrigerator door. Make sure the door is aligned with the cabinet and opposite door. Attach the hinge to the top of the cabinet. Do not tighten bolts completely.

On left-hand doors, pass the wires and water line through the top hinge pin. Then connect the water line and two connectors.

Attach the ground wire with a Phillips-head screwdriver at the right and left hinge.

Make sure the gasket on the door is flush against the cabinet and is not folded. Make sure the door is straight and the gap between the doors is even across the front. While holding the aligned door in place, tighten the top hinge bolts.

Reconnect the two connectors at each side of the top cap and reattach the three Phillips-head screws on top.

7

A

B

C

D

REMOVE THE FREEZER DOOR

Pull the freezer door open to full extension.

Remove the freezer bin by pulling both brackets upward at the same time. (See page 19.)

Take out the lower basket by lifting the basket up from the rail system. (See page 19.)

Remove the two 10 mm hex-head bolts from the right and left side.

29