Safety Information
Operating Instructions
Troubleshooting Tips
Customer Service
About the water softening system.
Service: Regeneration and Heavy Duty Backwash
NOTE: Each of the following functions has a factory set default value.
The defaults are: Regeneration start time
Regeneration (Start) Time: At the 2:00 AM regeneration start time, the water softening system begins regeneration at that time, ending at about 4:00 AM. This is a good time in most households because water is not in use (see Automatic Hard Water Bypass During Regeneration section). If a different time would be better for your needs, do steps 1, 2, 3, 5 and 7 below to change the starting hour.
Maximum Days Between Regeneration: The default setting allows the timer to control regeneration frequency based on water usage readings from the water meter. It provides the most economical operation. You can set a maximum time (in days) between regenerations. For example, no more than three days will pass without a regeneration occurring if you set dY 3 in the display. A
1 to 7 day setting is available. To make a change from the default setting, do steps 1, 3, 4, 5 and 7 below.
Heavy Duty Backwash: When set to ON, the backwash cycle of regeneration will be 10 minutes long instead of the normal seven minute length. This is beneficial on some water supplies high
in iron or sediment content. To conserve water, on clean supplies, be sure OFF shows. To change this setting, do steps 1, 3, 5, 6 and
7below.
1Beginning from the present time display, press and hold in the
SET button until begins to flash.AM
|
|
|
| RECHARGE TIME |
|
|
|
| ||
|
|
|
| Press the UP or DOWN button to display the desired start time. | ||||||
|
|
| 2 | |||||||
|
|
| The UP button moves the time ahead; the DOWN button | |||||||
|
|
|
| |||||||
SET | 3 | moves the time backward. |
|
|
|
| ||||
Press the SET button again, and |
|
|
|
| flashes. | |||||
|
|
|
|
| ||||||
| ||||||||||
|
| RECHARGE | ||||||||
|
|
|
| To set a maximum time (in days) between regenerations, press | ||||||
|
|
|
| |||||||
|
|
| 4 | |||||||
|
|
| the UP or DOWN button. |
|
|
|
| |||
|
|
|
|
|
|
|
| |||
|
|
|
| Press the SET button to display |
|
| . | |||
|
|
|
| Bkwash |
| |||||
|
|
| 5 | |||||||
|
|
|
|
|
| Heavy |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
6 Use the UP button to change the display to ON to increase the backwash time, if desired.
18