Safety Information |
Instructions |
Before you call for service…
Troubleshooting Tips
Problem | Possible Causes | What To Do |
|
|
|
Resin beads showing | Cracked distributor | • Call for service. |
up in drinking water |
|
|
and sink |
|
|
|
|
|
Sounds you might hear | Running water from the | • This is normal. |
| unit into a drain |
|
|
|
|
Water has air bubbles | Air in system after | • Will go away after it |
and is cloudy | installation | runs for a while. |
Operating |
|
Water hard sometimes | Using hot water while the |
| water softening system |
| is regenerating |
•Avoid using hot water during water softening system regenerations because the water heater will refill with hard water. See Automatic Hard Water Bypass During Regneration section.
Troubleshooting Tips |
|
Customer Service |
|
Timer hardness number | • Press and release the SET |
setting too low | button until HARDNESS |
| shows in the display. Be |
| sure the number shown is |
| the same as the actual |
| grains per gallon hardness |
| of your water supply. See |
| the Timer section if a |
| change in the setting is |
| needed. |
|
|
Grains of hardness | • Water hardness can change |
in your water supply | over time, especially in |
have increased | well water. To check, have |
| the water tested by a water |
| analysis laboratory or call |
| your local water |
| department. Adjust the |
| hardness number setting |
| as needed. |
24