GE PNSF39Z01 Proper Installation, Operating Instructions Troubleshooting Tips Customer Service

PROPER INSTALLATION

This water softening system must be properly installed and located in accordance with the Installation Instructions before it is used. If you did not receive Installation Instructions, you can receive one by calling us toll-free

at the GE Answer Center® 800.626.2000.

Safety Information

■Install or store where it will not be exposed to temperatures below freezing or exposed to any type of weather. Water freezing in the system will break it. Do not attempt to treat water over 100°F.

■Do not install in direct sunlight. Excessive sun heat may cause distortion or other damage to non-metallic parts.

■Properly ground to conform with all governing codes and ordinances. Follow details in Installation Instructions.

■Use only lead-free solder and flux for all sweat-solder connections, as required by state and federal codes.

■The water softening system requires a minimum water flow of three gallons per minute at the inlet. Maximum allowable inlet water pressure is 125 psi. If daytime pressure is over 80 psi, night time pressure may exceed the maximum. Use a pressure reducing valve if necessary. (Adding a pressure reducing valve may reduce the flow.)

WARNING: Discard all unused and packaging material after installation.

Operating Instructions

Troubleshooting Tips

Customer Service

5