To remove the control panel bracket:
1.Remove the control panel. (See Control Panel Assembly.)
2.Disconnect wire harnesses from the relay board at location CN3 and from the power board at location CN4.
3.Peel back the foam tape and release the wire harness to CN4 from the wire retainer.
4.Remove the 4
5.Slide the control panel bracket to the right then lift the control panel bracket from the control panel.
6.Guide the disconnected harnesses through the wire entry hole in the control panel bracket.
Wire Retainer
Wire Entry Hole
Foam Tape
To remove the control board:
1.Remove the control panel bracket. (See Control Panel Assembly.)
2.Disconnect the
3.Disconnect the wire harnesses from the selector board at locations CN9 and CN13.
4.Remove the 4
To remove the display board:
The display board is attached to the control panel by 2
Pin | Pin | |
|
(Continued Next Page)
– 27 –