Noise Filter
The noise filter is located behind the blower assembly on the right side of the oven. The noise filter is held in place by a single
Note: When installing the noise filter, ensure all filter wiring is connected to the correct terminals.
Top View of Noise Filter
Ground Wire Screw
Screw
Noise Filter
Check to make sure the fuse is good. Check the noise filter for approximate resistance value at the following locations:
White (neutral input) to white (neutral output) - 0 Ω
Black (line input) to black/brown (line output) - 0 Ω
White (neutral input) to black (line input) - 23 Ω
Front View of Noise Filter
Input
Wire
Harness
Capacitor and Diode
WARNING: Always be certain the capacitor is discharged before servicing. Mechanically discharge by placing an insulated handle screwdriver between the diode connection of the capacitor and the oven chassis ground.
Note: The capacitor has an internal discharge resistor that automatically discharges the capacitor when the oven turns OFF. Under normal operation, capacitor should fully discharge within 30 seconds.
The oven must be
partially removed toDiode access the capacitor. (See
Oven Removal / Partial
Removal.) The capacitorScrew is located behind the top
access cover and is held in place by 2
Note: When disconnecting the wires and diode from the capacitor, note wire and diode locations.
The capacitor wires have locking tabs. Remove the capacitor, capacitor bracket, and diode as one assembly.
– 30 –