GE Monogram 3900 Series, 5800 Series, 2900 Series WALL CASE WITH RAD10 DRAIN KIT, Screws, “A” “B”

36

WALL CASE WITH RAD10 DRAIN KIT

Internal Drain. See page 35 for external drain.

NOTE: SHADED PARTS AND SCREWS

INCLUDED WITH RAD10 DRAIN

KIT.THE 90° ELBOWTUBE IS

RECOMMENDED FOR INTERNAL

DRAIN INSTALLATION.

SCREWS	SEE DETAIL
	BELOW

“A” “B”

METAL PLASTIC

OVERFLOW RELIEF DRAIN

SEE NOTE 6

SQUARE DRAIN HOLES

NEOPRENE SPONGE GASKET

STEEL MOUNTING PLATE

NUT

(MOLDED CASE (RAB77) ONLY)

DETAIL

USE TYPE “A” SCREW FOR METAL CASE (RAB71)

AND TYPE “B” SCREW FOR MOLDED CASE (RAB77)

GASKET

CABINET BOTTOM

TUBE

1/2" OD

COVER

PLATE

1.The RAD10 drain kit is installed in the bottom of the wall case when it is desired to drain condensate to an internal drain system in the building.

2.The drain kit is mounted on the bottom of the wall case prior to installation of the case in the wall. It may be located anywhere on the room side portion except for sub-base installations. For these the drain should be at least 3" from the indoor edge of the case so as to adequately clear the sub-base.

3.A template is furnished with the kit for locating the necessary 3 holes in the case bottom - two to provide a securing means and one to provide a drain hole for the 1/2" od tubing.

(See details at left)

4.A tube or hose 1/2" I.D. (Obtained locally) must be installed on the drain tube and connected to the internal drain system in the building.

5.With the RAD10 the two square drain holes in the bottom outer flange of the wall case are sealed by the gaskets and mounting plates shown above.

6.Three (3) 1/2" diameter holes located 1/4" above the case bottom in the bottom outer flange provide overflow drainage to the outdoors when wind driven rain enters the chassis.

USE TYPE “A” SCREWS FOR BOTH RAB71 AND RAB77