GE Monogram 3900 Series Receptacles/Sub-Bases, Zoneline Chassis Nomenclature, Tandem, 265V 15 Amp

Zoneline® Chassis Nomenclature

The Zoneline chassis is identified by a model number defining the type of unit, cooling capacity, electrical information and optional features included on the unit. When specifying or ordering the Zoneline chassis use of this nomenclature will assure receiving the correct unit.

EXAMPLE

A	Z	5	8	H		1	2	D		A	D
Zoneline		Chassis series			Nominal cooling capacity				Universal
packaged		29=deluxe line cool/			07=7,000 BTUH cooling				power connection
terminal		electric heat			09=9,000 BTUH cooling
chassis		39=deluxe line heat pump			12=12,000 BTUH cooling				Special Features
		58=premium line			15=15,000 BTUH cooling				B=base unit
		heat pump							C=corrosion treated
						Voltage/Phase/			D=internal
		Unit type				Frequency				condensate
		E=cooling with electric				D=230/208 Volt, single				removal (ICR)
		resistance heat				phase, 60 Hz				system (heat
		H=heat pump with electric				E=265 Volt, single phase,				pump models
		resistance heat				60 Hz				only) (not for
										coastal areas)
									P=Dry Air 25

Receptacles/Sub-Bases

Tandem	Perpendicular	Large tandem		265V 15 Amp	265V 20 Amp		265V 30 Amp
230/208V 15 Amp	230/208V 20 Amp	230/208V 30 Amp
				NEMA7-15R	NEMA7-20R		NEMA7-30R
NEMA6-15R	NEMA6-20R	NEMA6-30R
Sub-Bases
	RAK204U	RAK204D15P	RAK204D20P	RAK204D30P	RAK204E15	RAK204E20		RAK204E30
Voltage	N/A	230/208	230/208	230/208	265	265		265
Amps	N/A	15	20	0	15	20		0
Receptacle	N/A	NEMA6-20R	NEMA6-20R	NEMA6-30R	NEMA7-15R	NEMA7-20R		NEMA7-30R

230/208-Volt sub-bases include appropriate power cord kit.

265-Volt units are to be direct connected. Cordset through enclosed chaseway into interior sub-base receptacle meets the NEC requirements.

Power connection kits

Power connection kits are required on all Zoneline chassis (see chart below).

The correct kit for the installation is determined by the voltage and amperage of the electrical circuit and the means of connecting the unit to the building wiring. If the unit is to be plugged into a receptacle, a line cord kit would be used; if the unit is to be permanently connected, a permanent connection kit would be used. 265-volt cord set units must be installed in compliance with National Electrical Code.

RAK3153/RAK3203/RAK3303 230/208-volt line cord connection kit

required on all models. See specification sheet for heater KW and branch circuit ampacity.

RAK4157/RAK4207/RAK4307	RAK5157/RAK5207/RAK5307
230/208-volt universal power	265-volt universal power
supply kit	supply kit

230/208-volt		Line cord connected units
LCDI Power Connection Kit	RAK3153		RAK3203	RAK3303
Heater KW	2.55/2.09		.45/2.82	5.00/4.09
Watts	2,550/2,090		3,450/2,820	5,000/4,090
BTUH	8,600/7,100		11,700/9,600	17,000/13,900
Amps	11.6/10.6		15.6/14.2	22.4/20.4
Min. circuit amps	15		20	0
Recommended	15-amp		20-amp	0-amp
protective	time-delay		time-delay	time-delay
device	fuse or breaker		fuse or breaker	fuse or breaker

*To be used with sub-base

265-volt	Permanent connected units* (Cord set)
RAK5172		RAK5202	RAK5302
2.55		.45	5.0
2,560		,450	5,000
8,600		11,700	17,000
10.3		13.8	19.6
15		20	0
15-amp		20-amp	0-amp
time-delay fuse		time-delay fuse	time-delay fuse

230/208-volt		Direct Connection Kit**
	RAK4157		RAK4207	RAK4307
Heater KW	2.55/2.09		.45/2.82	5.00/4.09
Watts	2,550/2,090		3,450/2,820	5,000/4,090
BTUH	8,600/7,100		11,700/9,600	17,000/13,900
Amps	11.6/10.6		15.6/14.2	22.4/20.4
Min. circuit amps	15		20	0
Recommended	15-amp		20-amp	0-amp
protective	time-delay		time-delay	time-delay
device	fuse or breaker		fuse or breaker	fuse or breaker

**To be used with sub-base or connection to building wiring

265-volt Direct Connection Kit**

RAK5157	RAK5207	RAK5307
2.55	.45	5.0
2,560	,450	5,000
8,600	11,700	17,000
10.3	13.8	19.6
15	20	0
15-amp	20-amp	0-amp
time-delay fuse	time-delay fuse	time-delay fuse

54