Genie 3511035556 manual Attach emergency release knob, cord, Tag, Attach limit switches, Switch

	MAIN ASSEMBLY
	OPEN GREEN PARTS BAG
	Screws for attaching light cover are included in this bag.
		Please set aside for use later.
14	14. Attach emergency release knob, cord
	and tag.
	• Tie an overhand knot in one end of
	emergency release cord [17].
	– Slide cord through center of knob [18].
		Fig. 1-17.
	–	Slide cord through hole in emergency
		release lever (on carriage).
	–	Tie a second knot in this end. Fig. 1-18.
	–	Slip wire of emergency release tag [19]
		through hole in emergency release lever
		and twist it around itself.

15. Attach limit switches.

• “CLOSE” limit switch [15B]. (Switches are identical.)

–Place “CLOSE” limit switch over top of rail about 12 inches from rail strap. Fig. 1-19.

–Check that white lever is toward power head.

–Insert set screw [16] into limit switch hand tight only to temporarily hold switch in place. Fig. 1-19A.

–Attach brown wire to switch. Fig. 1-19B.

–Leaving some slack in wire (Fig. 1-20), run wire down inside groove in top of rail back to power head.

–Use wire clip [44] to help maintain slack.

Fig. 1-20.

•“OPEN” limit switch [15A].

–Place “OPEN” limit switch over top of rail about 12 inches from power head. Fig. 1-21.

–Check that white lever is on side away from power head. (This means limit switches hang off opposite sides of rail. Check this to help verify they are installed properly.)

–Insert set screw [16] into limit switch hand tight only to temporarily hold switch in place.

–Attach grey wire to switch. Fig. 1-21.

–Leaving some slack in wire (Fig. 1-21), run wire down inside groove in top of rail back to power head.

–Use wire clip [44] to help maintain slack. Fig. 1-21.

•Coil excess wire and tape it to top of power head. Fig. 1-21A.

[16] [44]

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

release

knob

cord

Fig. 1-17

tag

Fig. 1-18

set screw

A

B

Fig. 1-19

“close”	brown wire
switch

wire clip

Fig. 1-20

“open” switch

grey wire

A

#8-32 x 3/8" Hex head screw Wire clip Fig. 1-21