Genie 3511035556 SECT 8-BATTERY & VISOR CLIP, Settings Contact Reverse, Test contact reverse

SETTINGS (CONTACT REVERSE)

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

	Limit switch adjustments must be completed
	before running contact reverse test.
28	1. Test contact reverse.
	• Open door using wall control.
	• Lay 2" x 4" board* on floor in center of garage
	door opening. Fig. 7-3.
	• Close door using wall control.
	– Door should stop and reverse
	within 2 seconds of contacting the board.
	– If door does not reverse properly:
	a. Decrease closing force a small amount
	by turning the “CLOSE” force adjustment
	screw slightly counterclockwise.
	b. Test contact reverse again.
	c. Repeat steps a. and b. until contact	Fig. 7-3
	reverse works properly.

*If you don’t have a 2" x 4" board handy, any object 1-1/2 inches high that can withstand being hit by the garage door without sustaining damage is fine.

NOTE: If door is stopping but not reversing, “CLOSE” limit switch must be moved closer to door.

SECT 8—BATTERY & VISOR CLIP

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

1.Install/replace battery Fig. 8-1.

•Using a pen or similar object, gently push in on tab.

•Cover snaps open. Remove old battery.

•Observe polarity markings (+,-) inside battery compartment.

•Match new battery to polarity markings and

instal new A23, 12 Volt battery.

•Replace battery cover.

NOTE: Use only A23, 12 Volt battery.

2.Attach visor clip Fig. 6-1.

•Slide clip in slot on back of remote control.

–Snap in place.

Visor Clip

Battery

Cover

Model

Number

Battery

Fig. 8-1