Genie 3511035556 top of door, centerline, attached board for, door bracket, extra thickness, 12A

INSTALLATION

FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM

	9. Mounting door bracket [21].	WOODEN ONE-PIECE
	• Center of bracket must be on centerline of
20	door and must be mounted as high as		top of door
	possible. Fig. 2-12A & B.	centerline
	• Hold bracket against door at preferred
	location and mark screw holes.
	– for wooden doors, drill 5/32 inch
	pilot holes.
	a. Fasten door bracket using
	3 lag screws [22].
	b. Check thickness of door against lag		attached board for
	screws. (It may be necessary to	door bracket
			extra thickness
	mount door bracket on a 2" x 6",
	etc. attached to inside of door to	Fig. 2-12A
	prevent screws from coming out
	other side of garage door.
	Fig. 2-12A.
	– for light-weight doors		top of door
	CAUTION: In the case of sectional doors, the
	door bracket must not be below the highest set	centerline
	of rollers. Fig. 2-13.
	– there are a wide variety of reinforcements
	depending on manufacturer and some are
	equipped with hardware that is intended	door bracket
	to be used in place of the door bracket.
	Be sure to confirm proper use of
	this hardware with your door	LIGHT-WEIGHT SECTIONAL
	manufacturer. Unauthorized improper
	use of these attachment systems	Fig. 2-12B
	could void your warranty.
	WHEREVER POSSIBLE—USE DOOR
	BRACKET SUPPLIED WITH YOUR
	GENIE OPERATOR.
	a. Fasten door bracket using	even with or
	3 self-drilling screws [47].	above top roller
		Fig. 2-13

[22] [47]

1/4" x 2" Lag screw 1/4"-20 Self-drilling screw