Genie 3511035556 manual Safe-T-Beam Installation, Check the following

SAFE-T-BEAM ® INSTALLATION

CAUTION

FOR HELP- GENIECOMPANY.COM

Staples which are too tight can cut or pinch wires. Cut or pinched wires can cause the STB System to stop working. When using the insulated staples, make sure you fasten them only as tightly as needed to hold the wire snugly.

≈ 1/2"

23

•Make wire attachments at STBs.

–Split and strip wire ends to be connected as shown Fig. 3-6.

–Loosen terminal screws.

–Insert wire under flat plate and tighten screw. It does not matter which wire, white or striped, goes on which terminal Fig. 3-7.

•Make wire attachments at power head.

–STBs are connected to terminals #3 and #4 on power head Fig. 3-8. It does not matter which wire, white or striped, goes on which terminal.

4.Check the following.

•Ensure that no part of door or its hardware is in path between lenses of source and sensor.

•Ensure that tops of lenses are between 5"-6" above the floor Fig. 3-9. The brackets are flexible, and can be adjusted slightly if needed.

NOTE: Safe-T-Beam® alignment check will be performed following connection to electrical power (see page 26). DO NOT PLUG IN YET!

(See Illustration on page 3 for a full view of Safe-T-Beam®location.)

≈ 1-1/4" to 1-1/2"

Fig. 3-6

Fig. 3-7

Fig. 3-8

top edge of lens between 5" - 6" above floor.

Fig. 3-9