Genius NT 250 Remote Control Feature, Remote Control Software Installation, Connecting The Nt

NT 250 Technical and Maintenance Manual NicomUsa Inc

REMOTE CONTROL FEATURE

The NT 250 is equipped with a 9 pin RS 232 connector that allows all the mains telemetry functions. The software is supplied with the unit and with this CD rom it's possible to monitor and to change the main parameters ot the NT 250 on the computer's screen.

The NT 250 is also supplied with the interlock connector that allows to switch the power on and off simply by grounding the inner conductor of the BNC.

NOTE:

The CD Rom supplied contains the remote control software of the NT 250.

REMOTE CONTROL SOFTWARE

INSTALLATION

The NT 250 comes with a Serial port RS 232. This port allows a Bi-Directional remote control of the unit from a PC.

INSTALLING THE SOFTWARE

1.Insert the NT 250 CD-ROM into the CD drive.

2.Run Setup.exe file found in the main folder of the CD-ROM. The installation will continue automatically asking only for the name of the folder of the hard drive where the program will be installed. It will be necessary to reboot the computer.

3.Once installed, the Tx_Nicom program icon can be recalled by clicking : Start - Programs - Tx_Nicom icon.

CONNECTING THE NT 250

The NT 250 is equipped with a Serial Port (RS232) in the rear panel. To connect the computer with the NT 250 we recommend standard serial cables Pin-to-Pin; the lenght of the cable must stay within 60 feet.

REMEMBER TO CLOSE THE PROGRAM BEFORE REMOVING THE CONNECTING CABLE

Page 3