JVC RX-8040B manual Connecting the Power Cord, Putting Batteries in the Remote Control

Notes:

•The signal-reachable distance may differ depending on the operating conditions and circumstances. To improve transmitting conditions, change the distance to the receiver and the direction to transmit while operating the remote control.

•To avoid a failure in the reception from the remote control, keep the connecting cables and the IR signal transmitter’s cable away from the RF rod antenna.

Setting up the IR signal transmitter

The IR signal transmitter can retransmit the IR signals. The transmitter allows you to use the AV COMPULINK remote control system, and to operate other manufacturers’ components without aiming the remote control directly at the remote sensors on the target components. In addition, the IR signal transmitter reduces the possibility of malfunction.

•The IR signal transmitter may not operate the target components depending on the operating conditions and circumstances— including the aiming angle and direction of the IR signal transmitter at the remote sensors of the target components. If this occurs, changing its aiming angle and direction at the remote sensors may solve the problem.

Connecting the Power Cord

Before plugging the receiver into an AC outlet, make sure that all connections have been made.

Plug the power cord into an AC outlet.

Keep the power cord away from the connecting cables and the antenna. The power cord may cause noise or screen interference.

Note:

The preset settings such as preset channels and sound adjustment may be erased in a few days in the following cases:

–When you unplug the power cord.

–When a power failure occurs.

CAUTIONS:

•Do not touch the power cord with wet hands.

•Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp the plug so as not to damage the cord.

1.Find a place where you can attach the IR signal transmitter.

•Place the transmitter where the signal can reach the remote sensor of the target components in a direct line of sight.

•If the cord length of the IR signal transmitter is not long enough, use an extension cord (not supplied).

2.Attach the double-sided adhesive tape (supplied) to the IR signal transmitter.

IR Signal Transmitter

or

Double-sided

Adhesive Tape

3.Connect the plug of the transmitter to the IR OUT terminal of the receiver and attach the transmitter.

Target component(s)

RF REMOTE

IR OUT

ANTENNA

At an angle of

approx. 60°

Putting Batteries in the Remote Control

Before using the remote control, insert the two supplied batteries

first.
1	2	3
	R6(SUM3)
	/AA(15F)

1.On the back of the remote control, remove the battery cover.

2.Insert the batteries.

• Make sure to match the polarity: (+) to (+) and (–) to (–).

3.Replace the cover.

If the remote control cannot transmit signals or operate the receiver correctly, replace the batteries. Use two R6(SUM3)/AA(15F) type (alkaline) dry-cell batteries.

Notes:

•When you aim the remote control directly at the remote sensor on the receiver, you can operate the receiver at a distance of up to 7 m (23 feet).

•After replacing the batteries, set the manufacturers’ codes again (see pages from 59 to 62).

Signal-emitting angle of the transmitter
Horizontally: 60˚	Vertically: 60˚
	15°
30°	45°
30°

CAUTIONS:

Follow these precautions to avoid leaking or cracking cells:

•Place batteries in the remote control so they match the polarity:

(+) to (+) and (–) to (–).

•Use the correct type of batteries. Batteries that look similar may differ in voltage.

•Always replace both batteries at the same time.

•Do not expose batteries to heat or flame.

15